Description:
SKD08 test clips are used for chips with spacing greater than 0.3mm. The method of holding small chip pin: Wobble the hand gently and push froard slightly.
After use, don’t force the clip off from the chip pin. To push out the clip and gently remove it from the chip pin.
If it can’t hold the chip pin, please refer to the picture: Adjust the front end of the clip with tweezers to make the angle close to 90 degrees.
High performance and it is in great reliability, cause it has been through testing standards.
Model: SDK08; Voltage: 40V; Current: 2A.
Specification:
Size: 60x40x20mm
Package Includes:
10x Micro IC Clamp
Note:
Conversion: 1inch=2.54cm, 1cm=0.393inch
Please allow slightly 0-1cm difference due to manual measurement.
Colors can appear different depending on light and how the listing is viewed.
Thanks for your understanding and attention. Wish you a pleasant shopping experience!